General Arrangement Drawing; Certification; Other Relevant Documentation And Manuals; Supplementary User Instructions - Flowserve 71576286 User Instructions

8.2.5 Parts list pumps 65 FP, 80 FP, 100 FP, 125
FP
N DESIGNATION
1130 Suction casing
1140 Discharge casing
1150 Stage casing
1410 Diffuser
1470 Diffuser plate
1500 Casing wear ring
2110 Pump shaft
2250 Impeller
2410 Interstage sleeve
2450 Shaft sleeve
2520 Loose collar
2540 Thrower
2905 Washer
2910 Shaft nut
3011-01 Radial ball bearing
3011-02 Radial ball bearing
3134 Support foot
3200 Bearing housing
3260 Bearing cover
3853 Grease nipple

8.3 General arrangement drawing

The typical general arrangement drawing and any
specific drawings required by the contract will be sent
to the Purchaser separately unless the contract
specifically calls for these to be included into the User
Instructions. If required, copies of other drawings
sent separately to the Purchaser should be obtained
from the Purchaser and retained with these User
Instructions.
FP USER INSTRUCTIONS ENGLISH 71576286 - 07/06
N DESIGNATION
4120 Gland
4130 Gland packing
Stuffing box neck
4132
bush
4590 Gasket
Round section joint
4610
ring
6515 Drain plug
6544 Circlip
6571 Tie bolt
6572 Stud
6577-01 Hexagon head bolt
6577-02 Hexagon head bolt
6578 Threaded plug
6581-01 Hexagon nut
6581-02 Hexagon nut
6581-03 Hexagon nut
6581-04 Hexagon nut
6700-01 Key
6700-02 Key
9331 Cover plate
Page 34 of 35

9 CERTIFICATION

Certificates determined from the Contract
requirements are provided with these instructions
where applicable. Examples are certificates for CE
marking, ATEX marking etc. If required, copies of
other certificates sent separately to the Purchaser
should be obtained from the Purchaser for retention
with these User Instructions.
10 OTHER RELEVANT
DOCUMENTATION AND MANUALS

10.1 Supplementary User Instructions

Supplementary instructions such as for a driver,
instrumentation, controller, seals, sealant system etc
are provided as separate documents in their original
format. If further copies of these are required they
should be obtained from the supplier for retention
with these User Instructions.

10.2 Change notes

If any changes, agreed with Flowserve Pump Division,
are made to the product after its supply, a record of the
details should be maintained with these User
Instructions.

10.3 Additional sources of information

Reference 1:
NPSH for Rotor dynamic Pumps: a reference guide,
Euro pump Guide No. 1, Euro pump & World Pumps,
Elsevier Science, United Kingdom, 1999.
Reference 2:
th
Pumping Manual, 9 edition, T.C. Dickenson,
Elsevier Advanced Technology, United Kingdom, 1995.
Reference 3:
nd
Pump Handbook, 2 edition, Igor J. Karassik et al,
McGraw-Hill Inc., New York, 1993.
Reference 4:
ANSI/HI 1.1-1.5, Centrifugal Pumps - Nomenclature,
Definitions, Application and Operation.
Reference 5:
ANSI B31.3 - Process Piping.