Sena STS Series User Manual page 71

The user must manually select WIRELESS LAN CARD as the card type and set the primary and
secondary DNS servers when configuring a PC LAN card. All other configuration steps are the same
as detailed in Section 3.1 IP Configuration.
The STS Series supports SSID(Service Set Identifier) and WEP(Wired Equivalent Privacy) key
features for the wireless LAN configuration. The user may configure the SSID to specify an AP
(Access Point). The user may also configure the WEP mode as either encrypted or shared. The WEP
key length must be either 40 or 128 bits. The 40-bit WEP key length requires the user to enter 5
hexadecimal code sets without colons (:). The 128 bits WEP key length requires the user to enter 13
hexadecimal code sets without colons (:).
For example, to use the 128 bits WEP key length option, the user must enter 13 hexadecimal
code sets as follows:
Figure 5-4 PC wireless LAN card configuration
000F25E4C2000F25E4C2000F24
71