Using Wps To Connect To A Network; Wi-Fi Protected Setup - Epson DS-560 User Manual

Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access
point. If there is no hardware button, there may be a virtual WPS button in the software for the device.
Check your network product documentation for details.

Using WPS to Connect to a Network

Using WPS PIN Mode to Connect to a Network
Parent topic:
Using WPS to Connect to a Network
If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to
connect your scanner to the network.
1. Set the connection mode on the scanner to Wi-Fi.
2. Open the input tray and turn on the scanner.
3. Press and hold the Connect button for at least 3 seconds until the Status and ! error lights flash
alternately.
The scanner enters standby status for WPS connection for two minutes.
Wi-Fi Networking
38