Setting The Dip Switches; Function Setting - Fujitsu Slim Duct Type Installation Manual

10.2. Setting the dip switches

Set the remote controller DIP switches.
[Example]
Front case (back side)
DIP switch 1
SW state
NO.
OFF ON
1
2
3
DIP-
4
switch 1
5
6 Invalidity Validity
OFF ON
1
2
3
4
5
6
ON
Detail
Cannot be used.
(Do not change)
Dual remote controller setting
* Refer to 2. DUAL REMOTE
CONTROLLERS in 11
SPECIAL INSTALLATION
METHODS.
Cannot be used.
(Do not change)
Cannot be used.
(Do not change)
Cannot be used.
(Do not change)
Memory backup setting
* Set to ON to use batteries
for the memory backup. If
batteries are not used, all
of the settings stored in
memory will be deleted if
there is a power failure.
( Factory setting)

10.3. Function setting

This procedure changes the function settings used to control
the indoor unit according to the installation conditions. Incorrect
settings can cause the indoor unit to malfunction. This proce-
dure should be performed by authorized installation or service
personnel only.
Perform the "FUNCTION SETTING" according to the installation
conditions using the remote controller. (Refer to the indoor unit
installation manual for details on the function numbers and set-
ting values.)
(1) Press the SET TEMP. buttons (
simultaneously for more than 5 seconds to enter the function
setting mode.
SU MO TU WE TH FR SA
(2) Press the SET BACK button to select the indoor unit num-
ber.
SET BACK
SU MO TU WE TH FR SA
Unit number of INDOOR UNIT
(3) Press the SET TIME (
number.
SU MO TU WE TH FR SA
Function number
) ( ) and FAN button
) buttons to select the function
En-19