Table of Contents
Advertisement
Service Procedures (cont.)
Remove/Install the x2 SE Fenders and Fender Frames
Tools Required: 4 mm hex bit, torque wrench
To remove the x2 SE Fender and Frame assembly from the PT:
1.
Make sure the Segway PT is unplugged and powered off.
2.
Remove the three 28 mm fasteners using a 4 mm hex wrench (see
Figure 72).
3.
Lift off the Fender and Frame assembly and clean all debris from
the mounting surfaces.
4.
To remove the Fender from the Fender Frame, remove the four
18 mm fasteners using a 4 mm hex wrench (see Figure 73).
To install the x2 SE Fender and Frame assembly to the PT:
1.
Thread the three 28mm long fasteners through the Fender and
Frame assembly into the gearbox cover.
2.
Using a 4mm hex wrench, torque to 6.0 N-m (4.4 ft-lbf).
112
Fender and Fender Frame assembly
Figure 72: Remove/Install the x2 SE Fender/Fender Frame Assembly
Fender Frame
Figure 73: Remove the Fender from the Fender Frame
28 mm Fasteners
Fender
18 mm Fasteners
Hide quick links:
Advertisement
Table of Contents
