Longhand Programming - Avaya IP Office 2410 User Manual

Longhand Programming

1. Press Admin or
2. To switch to longhand programming mode, press Expl?
3. Press Next
4. If the function requires some data to be entered, [ ] is shown at the bottom of the display. Enter
the data using the normal telephone keypad.
5. The upper part of the display reverts to showing the functions currently assigned to each
.
6. To move between the pages of display keys, press
7. To select the display key against which to program the new function, press
Caution
Do not select the slot used for the Admin function. Replacing this function will lock the phone for
further programming until reset through the telephone system.
8. If the display slot is not already used, the display shows BUTTON PROGRAMMED!.
•
To end programming, press
•
To continue programming other functions, press
9. If the display slot already has a programmed function, the display shows FEATURE ON
BUTTON. Press
display.
•
Press Repla
PROGRAMMED! is displayed.
•
To keep the existing function and forget the function just programmed, press Keep
•
To delete the existing function and forget the function just programmed, press Delete
2410 and 5410 User Guide
IP Office
Admin 1. See Display Key Programming.
until the required function required is shown, then press Selct
or until Repla, Keep and Delet are shown along the right-hand edge of the
to replace that existing function with the one just programmed. BUTTON
.
and .
EXIT.
Cont.
15-601076 Issue 05b (28th February 2008)
Function Keys
.
and
or .
.
.
Page 45