HP Surestore fc 1Gb/2Gb switch 16B Installation And Reference Manual page 23

2. Record the IP address for future reference.
3. Connect the switch to the workstation computer by Ethernet cable (can be a direct
connection or through a network) by completing the following steps:
a. Remove the shipping plug from the Ethernet port.
b. Insert one end of an Ethernet cable in the Ethernet port.
c. Connect the other end of the Ethernet cable to the workstation or to an Ethernet
Note The switch can now be accessed remotely and from multiple connections using
telnet or Web Tools. Ensure that the switch is not being modified from any other
connections during the remaining steps.
4. Log on to the switch with administrative privileges by telnet. The default administrative
logon is
CAUTION Do not change the default password unless local administration policy
requires it.
5. Modify the domain IDs if desired by completing the following steps:
Note The default domain ID is 1. If the default domain ID is already in use when the
switch is connected to the fabric, the domain ID for the new switch is automatically
reset to a unique value. The domain IDs that are currently in use can be determined
using the telnet command
a. Disable the switch by entering the following:
b. Enter the following:
c. Enter the following at the
d. Enter a unique domain ID:
e. Complete the remaining prompts (or press CTRL+D to accept the remaining settings
f. Re-enable the switch by entering the following:
6. Optional: Specify any custom status policies for the fabric by completing the following
steps:
a. Enter the following at the prompt:
b. Specify the desired status policies. To completely deactivate the alarm for a particular
HP Surestore FC 1Gb/2Gb Switch 16B Installation and Reference Guide
Installing and Configuring the HP Surestore FC 1Gb/2Gb Switch 16B
network containing the workstation.
and the default password is
admin
fabricShow
configure
without completing all the prompts).
condition, enter "0" at the prompt for that condition.
.
password
.
switchDisable
prompt:
Fabric parameters
Domain: (1..239) [1] 3
switchEnable
switchStatusPolicySet
2
y
2-11