HP Surestore fc 1Gb/2Gb switch 16B Installation And Reference Manual page 22

2
Installing and Configuring the HP Surestore FC 1Gb/2Gb Switch 16B
f. From the terminal emulator application, log on to the switch with administrative
CAUTION Do not change the default password unless local administration policy
requires it.
g. Enter the following at the prompt:
h. Enter the following information at the corresponding prompts, listed below:
i. You can verify the address was correctly set by entering the following:
j. Record the IP address on the label provided for this purpose on the FC 16B.
k. Once the IP address is verified as correct, remove the serial cable and replace the
Note The serial port is intended only for use during the initial setting of the IP
address and for service purposes. Using the serial port during normal switch operation
or for regular maintenance is not recommended.
2-10
– In a Windows 95, 98, 2000, or NT environment:
Parameter
Bits per second:
Databits:
Parity:
Stop bits:
Flow control:
– In a UNIX environment, enter the following string at the prompt:
ttyb -9600
privileges through the serial connection. The default administrative logon is
and the default password is
–
Ethernet IP Address
–
Ethernet Subnetmask
–
Fibre Channel IP Address [none]
address if desired.
–
Fibre Channel Subnetmask [none]
mask if desired.
– [172.17.1.1]: Enter the new gateway address.
Gateway Address
–
Set IP address now? [y = set now, n = next reboot]
to set now.
shipping plug in the serial port.
Value
9600
8
None
1
None
.
password
ipAddrSet
[10.77.77.77]: Enter the new Ethernet IP address.
[0.0.0.0]: Enter the new Ethernet subnetmask.
: Enter the new Fibre Channel IP
: Enter the new Fibre Channel subnet
HP Surestore FC 1Gb/2Gb Switch 16B Installation and Reference
tip /dev/
admin
: Enter "y"
ipAddrShow