Configuration (Standalone Modes); Standalone Static; Sound-Active Mode; Auto Selection - Chauvet Circus User Manual

Configuration (Standalone Modes)

Set this product in one of the standalone modes to control it without a DMX controller.
1) Connect this product to a suitable power outlet.
2) Turn this product on.

Standalone Static

To enable the Standalone Static mode, do the following:
1) Press <MENU> repeatedly until CL-X shows on the display.
2) Use <UP> or <DOWN> to select a color (CL.r, CL.g, CL.b, CL.y, or CL.u).

Sound-Active Mode

To enable the Sound-Active mode, do the following:
1) Press <MENU> repeatedly until SOUn shows on the display.
2) Press <ENTER>.
3) Turn the music on.
4) Press <MENU> repeatedly until SE.00~31 shows on the display.
5) Use <UP> or <DOWN> to adjust the microphone sensitivity

Auto Selection

To enable the Auto Selection mode, follow the instructions below:
1) Press <MENU> repeatedly until
2) Press <ENTER>.
3) Use <UP> or <DOWN> to select the desired program.
4) Press <ENTER>.

Auto Configure

This product has 42 built in light shows (auto programs). In this mode, it will cycle
through each of those programs.
To enable the Auto Configure mode, follow the instructions below:
1. Plug the fixture into power.
2. Press <MENU> until AUTO appears on the display.
3. Press <ENTER> to scroll until you reach n.***.
4. Use <UP> or <DOWN> to adjust the time the light show runs (000~100) before
5. Press <ENTER> until you reach SP**.
6. Use <UP> or <DOWN> to adjust the run speed between 00~99 or FL (full run
7. Press <ENTER> until you reach SF**.
8. Use <UP> or <DOWN> to adjust the strobe speed between 00~99 or FL (full
9. Press <ENTER>.
Page 10 of 14
Never connect a fixture that is operating in any standalone mode, whether
Static, Automatic, or Sound to a DMX daisy chain connected to a DMX
controller. This is because fixtures in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
The fixture will illuminate in the chosen color until re-configured or turned
off.
fixture starts reacting to the beat of the music.
The fixture will only respond to the low frequencies of the music (bass and
drums).
The playback speed is not adjustable in this mode.
proceeding to the next.
speed).
strobe speed).
n.000~10: Modifies the light show time progression
SP.00~99, Modifies the run speed
FL:
SF.00~99, Modifies the strobe speed
FL:
(S_ _1~S100)
shows on the display.
Pr.XX
Circus User Manual (Rev. 3)
until the