Philips Avent SCD480 Instructions Manual page 11

adapter
Only replace the adapter of the parent unit with an adapter of the original type. You can order a
new adapter from your dealer or a Philips service centre:
- SBC CS0920/00W (EU/SGP only)
- SBC CS0920/05W (UK only)
- 9VD200 (AU/NZ only)
Environment
Do not throw away the appliance with the normal household waste at the end of its life, but
,
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 11).
Batteries contain substances that may pollute the environment. Do not throw empty
,
batteries away with the normal household waste, but hand them in at an official collection
point. Always remove the batteries before discarding the appliance or handing it in at an
official collection point. (Fig. 12)
guarantee and service
If you need service or information or if you have a problem, please visit the Philips AVENT website
at www.philips.com/avEnt or contact the Philips Consumer Care Centre in your country (you
can find the phone number in the worldwide guarantee leaflet). If there is no Consumer Care
Centre in your country, go to your local Philips dealer.
Frequently asked questions
This chapter lists the questions most frequently asked about the appliance. If you cannot find the
answer to your question, contact the Customer Care Centre in your country.
Question
Why is the power-on
light not on?
Why does the power
on light flash red?
Why does the parent
unit produce a high
pitched noise?
Why is there no
sound coming from
the parent unit?
Answer
Perhaps the appliance plug has not been inserted properly into the
socket on the unit, or perhaps the adapter has not or not properly been
inserted into the wall socket.
You may also have forgotten to switch on the units. Press the on/off
button on the baby unit and turn the volume control on the parent unit
downwards to switch on the units.
If you operate the units on batteries, the batteries may be low. In that
case, replace the batteries.
You are operating the unit on batteries and the batteries are low.
Replace the batteries.
The units are too close together. Move the parent unit at least 1 metre/3
feet away from the baby unit. If this does not help, the volume is too
high. Turn the volume control to a lower volume.
Check if the volume is set high enough. If the volume is too low, turn the
volume control to a higher volume. Also check the microphone
sensitivity of the baby unit.
EngliSh
11