Table of Contents
Advertisement
Erasing a selection
Temporarily overriding a
previously saved program
Erasing a program
44
Y ou also may erase a selection from a previously saved program. To erase a selec-
tion:
1. Load a CD for which you've already saved a program (the letter
will appear preceding the track number on the display); or load an
unprogrammed CD, then assemble and save a program.
2. Using the
next
and
or the numbered buttons on the remote), select the track you want
to erase from your program.
3. Erase the selection to your program by pressing
remote control, press
Note: Y ou must press
seconds after making a selection, or the selection won't be re-
corded.
4. Repeat steps 2 and 3 for each selection you want to add to your
program. Make sure to press
each selection.
5. When you've finished adding selections, press
display will show
PROG CHANGED
your change permanent.
To override a previously saved program (temporarily), press
the Remote Control, press the
will show
PROG CLEARED
All of the CD's tracks will be accessible for basic operation, but the program will
still be retained in the Nº31.5's memory . (See Basic Operation.)
Note: If you press
program save
display will show
PROG DELETED
from the Nº31.5's memory .
To erase a previously saved program permanently from the Nº31.5's memory:
1. Press
program clear
2. Press
program save
Once again, this last step of pressing
permanent (as opposed to merely overriding the program this once).
previous
(or
track +
and
, then press
).
prg/time
–
(or
program –
prg/time
program –
(or
prg/time
. This last step is what makes
numbered key, then press
0
.
after pressing
and the program will be erased
; the display will show
PROG CLEARED
; the display will show
PROG DELETED
program save
P
track –
on the remote,
program –
(on the
and
) within five
–
and
–
) after
; the
program save
program clear
); the display
prg/time
program clear
, the
.
.
is what makes your change
(on
Advertisement
Table of Contents
