Changing Slim Select Bay Modules; Removing A Module - Toshiba Portégé M100 User Manual

2. Position a new cap on the peg and press it into place.
NOTE: The peg is square, so be careful to align the cap's square hole
with the peg.

Changing Slim Select Bay modules

This section explains how to change modules in the Slim Select Bay. The illustra-
tions show replacement of the DVD-ROM drive with the Slim Select Bay HDD
adaptor. Therefore, the text refers to those modules. However, the procedures are
the same for any of the modules: CD-RW/DVD-ROM drive, HDD adaptor, Slim
Select Bay 2nd battery pack with separate tray or weight saver.
CAUTIONS: 1. To avoid injury, do not put your hand into the Slim
NOTE: The TOSHIBA Mobile Extension is preinstalled to support hot
swapping under Windows. Refer to Chapter 1,
tion on using this utility to change modules while the computer's power
is on.

Removing a module

Remove the DVD-ROM drive as described below.
1. Check all disk indicators to make sure no disks are operating.
2. Turn the computer upside down.
CAUTION: Wait for all disk indicators to go out before you turn over the
computer and be careful to lay the computer down gently. Shock can
damage the HDD or other components.
3. Slide the Slim Select Bay latch to the unlock position.

Changing Slim Select Bay modules

Select Bay slot.
2. Before removing or inserting a second battery pack,
turn off the computer's power.
Introduction for informa-
4-3