Disconnecting 3 ½" Diskette Drive; Changing Slim Select Bay Modules - Toshiba Satellite Pro M10 User Manual

Disconnecting 3 ½" diskette drive
When you have finished using the diskette drive, follow the procedures
below to disconnect it:
1. Wait for the indicator light to go out to make sure all diskette activity
has stopped.
If you disconnect the diskette drive or turn off the power while the
computer is accessing the drive you may lose data or damage the diskette
or the drive.
2. Open the Safety Remove Hardware icon on the system tray.
3. Click Diskette drive.
4. Pull the diskette drive connector out of the USB port.

Changing Slim Select Bay modules

This section explains how to change modules in the Slim Select Bay. The
illustrations show replacement of the DVD-ROM drive with the Slim Select
Bay HDD adaptor. Therefore, the text refers to those modules. However,
the procedures are the same for any of the modules: CD-RW/DVD-ROM
drive, DVD Multi drive, CD-R/RW drive, Slim Select Bay 2nd battery pack,
TOSHIBA Bridge media adaptor with separate tray or weight saver.
To avoid injury, do not put your hand into the Slim Select Bay slot.
Before removing or inserting a second battery pack, turn off the
computer's power.
The TOSHIBA Mobile Extension is preinstalled to support hot swapping
under Windows. Refer to Chapter 1, Introduction, for information on using
this utility to change modules while the computer's power is on. If you are
using a Bridge media adaptor, you can click the Windows Safety Remove
Hardware icon on the System tray (Task Bar) to remove the Bridge media
adaptor.
Satellite Pro M10 Series
Operating Basics
4-5