First Alert FA160C User Manual page 32

TROUBLE CONDITIONS (Continued)
4. SYSTEM LO BAT
* The beeping that
accompanies a low
battery display
(items 4 & 5) can be
5. LO BAT + zone descriptor
stopped by entering
an OFF sequence
(code + OFF).
6. MODEM COMM
** Not all systems use
wireless transmitters.
7. POWER indicator (if present) The system is operating on battery power only.
8. Busy-Standby (or dI)
9. OPEN CIRCUIT (or OC)
10. Long Rng Trbl (or bF)
(or BAT with no zone No.)
(or BAT with zone No.)
( o r CC)
is off. AC LOSS is displayed
(or NO AC)
– 32 –
Indicates that a low system battery condition exists;
this is accompanied by a once-per-minute "beeping"*
at the Keypad. CALL FOR SERVICE AT ONCE.
Indicates that a low battery condition exists in the
wireless transmitter** displayed; accompanied by a
once-per-minute "beeping"* at the Keypad. Replace
the battery in the affected wireless transmitter as
soon as possible (see page 36), or CALL FOR
SERVICE.
Indicates that the control is on-line with the central
station's remote computer. The control will not
operate while on-line. Wait a few minutes. The
display should disappear.
If only some lights are out on the premises, check
circuit breakers and fuses and reset or replace as
necessary. CALL FOR SERVICE IMMEDIATELY if
AC power cannot be restored to the system.
If this remains displayed for more than 1 minute, the
system is disabled. CALL FOR SERVICE
IMMEDIATELY.
The keypad is not receiving signals from the control.
CALL FOR SERVICE IMMEDIATELY.
If programmed, your back-up Long Range Radio
communication has failed. CALL FOR SERVICE
IMMEDIATELY.