Table of Contents
Advertisement
A A A A R R R R M M M M I I I I N N N N G G G G A A A A L L L L L L L L P P P P R R R R O O O O T T T T E E E E C C C C T T T T I I I I O O O O N N N N
Using the
Use this key when no one will be staying on the premises.
2
AWAY Key
When armed in AWAY mode, the system will sound an alarm if a protected door or
window is opened, or if any movement is detected inside the premises. You may leave
through the entrance door during the exit delay period without causing an alarm. You
may also re-enter through the entrance door, but must disarm the system within the
entry delay period or an alarm will occur.
Close all protected perimeter windows and doors before arming (see CHECKING
FOR OPEN ZONES section). The green READY indicator on the keypad should be lit
if the system is ready to be armed.
1.
2.
In a two-partition system, you can arm both partitions in the AWAY mode at the same
2-Partition AWAY
time if the same master code is assigned to both partitions. You can do this from either
Arming
partition's keypad.
This procedure is not applicable to disarming or any other system function.
(With Entry Delay ON)
AWAY
+
2
(Security Code)
ARMED
AWAY
**
**
YOU MAY EXI T NOW
The "You May Exit Now"
portion of the message
disappears when the exit
delay expires.
– 17 –
ENTER SECURITY CODE THEN PRESS AWAY
Example: 7 2 9 6 then press the AWAY key.
LISTEN
The keypad will beep twice, or beep continuously if exit
warning has been programmed for your system, and
displays the armed AWAY message. The red ARMED
indicator also lights.
(Continued)
Advertisement
Table of Contents
