Table of Contents
Advertisement
T T T T E E E E S S S S T T T T I I I I N N N N G G G G T T T T H H H H E E E E S S S S Y Y Y Y S S S S T T T T E E E E M M M M
Using the
The TEST key puts your system into the Test mode, which allows each protection
point to be checked for proper operation. The keypad sounds a single beep every 40
5
TEST Key
seconds as a reminder that the system is in the Test mode.
Note: An alarm message will not be sent to be sent to your alarm monitoring
1.
*** DI SARMED ***
READY TO ARM
2.
(Security Code)
3.
4.
(TO BE CONDUCTED WEEKLY)
company during the following tests.
DISARM THE SYSTEM
Disarm the system and close all protected windows,
doors, etc. The "Ready" message should be displayed
and the green READY indicator lit.
TEST
+
5
ENTER THE SECURITY CODE THEN PRESS TEST
Example: 7 2 9 6 then press the TEST key.
LISTEN
The external sounder should sound for 2 seconds and
then turn off.
If the sounder does not sound, CALL FOR SERVICE
IMMEDIATELY.
FAULT ZONES
Open each protected door and window in turn and listen
for three beeps from the keypad. Identification of each
faulted protection point should appear on the display.
The display will clear when the door or window is closed.
– 29 –
(Continued)
Advertisement
Table of Contents
