Make Electrical Connection - Maytag 30” BUILT-INMICROWAVE OVEN COMBINATION Installation Instructions Manual

TO REMOVE OVEN DOOR
(NON-SELF-CLEANING MODELS)
Removing the oven door may make it easier to clean
the oven. To remove the door, first open it to the first
stop (about 4 inches or 10 cm). Take hold of both
sides of the door near the top; then lift it at the same
angle it is in.
With the door off, you will notice how the ends of
hinges slide into slots at the bottom corners of the
door. To put the door back on, fit both corners of the
door over the ends of the hinges. Push the door
down evenly, so neither corner gets ahead of the
other. When it reaches the bottom, you can close
the door. A safety latch will hold the door open until
it is on correctly.
'2
Pull slralghl wllh the
angle of part-open door
Push down evenly
Removing the oven door: (For installing and
cleaning)
8
Make electrical connection
GROUNDED
UNGROUNDED
NEUTRAL
NEUTRAL
JUNCTION
FROM POWER
BOX \
SOVRCE
JUNCTION
FROM POWER
SOURCE
FIGURE 3
-.
FROM
APPLIANCE
COPPER
GROUND W
GROUNDED COLD
NUTS FIRMLY
(MUST BE TIGHT
ON PIPE)
FIGURE 4
1
- WHITE
ACK
FTOM \ STRAIN
FIGURE 5
APPLIANCE RELlEF
Grounding Instructions