Download Print this page

Electrical Requirements; Grounding Instructions; Operating Your Microwave Oven - Maytag MMV5219DH User Manual

Advertisement

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Observe all governing codes and ordinances.
Required:
A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a
fuse or circuit breaker.
Recommended:
A time-delay fuse or time-delay circuit breaker.
A separate circuit serving only this microwave oven.

OPERATING YOUR MICROWAVE OVEN

Settings
Clock
The Clock is a 12-hour (12:00-11:59) or 24-hour (0:00-23:59) clock.
Touch CLOCK/OPTIONS to reach Clock submenu, and follow the
prompts to set the clock. Clock format (12 hours with AM and PM or
24 hours) may also be set in the Clock submenu.
Kitchen Timer
With the microwave oven in standby mode, touch the Kitchen Timer
control, enter time, then touch the Kitchen Timer control or the Start
control. Cook functions may be entered while the Kitchen Timer is
counting down. To cancel timer, touch Kitchen Timer control while the
timer countdown is active in the display.
Control Lock
Activate to avoid unintended start. Touch and hold the Cancel control
for about 3 seconds until 2 tones sound and padlock icon appears in
the display. Repeat to unlock control.
Clock/Options
Nine options/settings may be adjusted: 1-Clock and Energy Save;
2-Scrolling Speed; 3-Sound; 4-Language (English or French); 5-Filter
Reset; 6-Fan Timer; 7-Light Timer; 8-Demo Mode; 9-Factory Reset.
Energy Save
To conserve energy, the Clock will automatically turn off when the
microwave oven goes into standby mode. Touch CLOCK/OPTIONS to
reach the Clock and Energy Save submenu, and follow the prompts to
turn on Clock.
Scroll Speed
Scroll speed of the text may be adjusted. Touch the CLOCK/OPTIONS
to reach the Scrolling Speed submenu, and follow the prompts to set
speed.

GROUNDING INSTRUCTIONS

For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS
This device complies with Part 18 of the FCC Rules.
Sound (Tones)
Programming tones and signals. Key beep tones may be turned off, or
all tones (including end-of-function signals) may be turned off. Touch
CLOCK/OPTIONS to reach the Sound submenu, then follow the
prompts to turn off or on the programming tones or all tones.
Language (on some models)
Language of the display text may be changed. Touch the CLOCK/
OPTIONS to reach the Language submenu, and follow the prompts to
set language to English or French.
Filter Reset
Reset the filter status after replacing and/or cleaning the filters. Touch
CLOCK/OPTIONS to reach the Filter Reset submenu, and activate reset.
Vent Fan
Various speeds, ranging from high to low, and off. Comes on
automatically as cooling fan during any cook function.
Fan Timer: Set vent fan to run for exactly 30 minutes, or to run for only
30 minutes more (off after 30 minutes). The vent fan may be turned off
at any time using the Vent Fan control. Touch CLOCK/OPTIONS to
reach the Fan Timer submenu, and select the setting.
Light Timer
Set the cooktop light to turn on and off at certain times. Touch
CLOCK/OPTIONS to reach the Light Timer submenu, and follow the
prompts to set the light on time and light off time in hours and minutes,
or to cancel Light Timer.
NOTE: Light Timer uses 12-hour clock only.
Demo Mode
Activate to practice using the control without actually turning on the
magnetron. Touch CLOCK/OPTIONS to reach the Demo Mode
submenu, the follow the prompts to activate. The DEMO icon will light
up in the display. Repeat to deactivate.
3

Advertisement

loading

This manual is also suitable for:

Mmv5219deMmv5219ds