Table of Contents
Advertisement
Your Eycasa main unit connects to your video door station. The process can take several seconds. The
setup wizard will signal whether the process is complete or whether it needs to be repeated due to a pairing
error.
If the message "Video door station was successfully paired" appears, the pairing process is finished. The
status LED goes out on your video door station, signaling readiness.
You can proceed with installation of the unit from Chapter 6.
Note:
If you want to test the video door station after initial start-up, note that there can be audio
feedback loops both in the loudspeaker of the door station and the main unit if the devices
are too close to each other. This is normal and occurs only when both devices are installed in
the same room.
17
English
Advertisement
Table of Contents
