Unpacking - PENSOTTI PCH 50B-H Instruction Manual

3.2 Unpacking

■ The materials (cardboard) used for packing the appliance are fully recyclable.
■ It is recommended that the packing material is only removed prior to installing the boiler. The manufacturer
will not be held responsible for damage caused by incorrect storage of the product.
■ Packing materials (plastic bags, polystyrene, nails, etc.) must not be left within reach of children, in that
these items represent a potential hazard.
A. Place the packed appliance on the floor (see fig. 1)
making sure that the "up" arrow is facing down. Remove
the staples and open out the four flaps of the box.
B. Rotate the boiler 90° while manually supporting it from
underneath
C. Lift the box and remove the protections. Lift the boiler
by grasping the rear part and proceed with the installation.
STORAGE & HANDLING
Please note that prior to installation the Pensotti boilers
should be stored in the horizontal position with no more
than three boilers to a stack;
Ensure that the boilers are stored in dry conditions and be
aware that the carton is a two-man lift;
3.3 Installing the boiler.
The appliance must be installed exclusively on a
vertical solid wall capable of supporting its weight.
■ The boiler should be fitted within the building unless
otherwise protected by a suitable enclosure i.e. garage
or outhouse. (The boiler may be fitted inside a
cupboard)
■ If the boiler is sited in an unheated enclosure then it is
recommended to leave the ON/OFF switch always in
ON position to give frost protection.
■ If the boiler is installed in a room containing a bath or
shower reference must be made to the relevant
requirements.
■ Appliance is approved for installation on combustible
walls.
In order to allow access to the interior of the boiler for
maintenance purposes, it is important that the minimum
distances indicated in figure 2 are respected.
INSTALLATION INSTRUCTIONS
A
C
B
Fig.1
L
X Y
MINIMUM DISTANCE [INCHES]
Model X Y L H A
RK 50 E/B 8 8 20 40 8
FigF
1
B
20
Fig.2
22 2
17