Worx Professional WU654 Safety And Operating Manual page 9

the sanding paper is even with the edges and that the sanding paper
is taut on the pad.
Remove the abrasive paper by pinching an edge and peeling off. (See
Fig B)
2
CYCLONIC DUST BOX (See Fig. C)
10
A) ATTACH THE CYCLONIC DUST BOX
Your sander is equipped with a cyclonic dust box. To attach, slide
the box onto the outlet piece and take care that the latching lever
9
engages. Pay attention to the gap on top of the box and locking in the
pin of housing.
Caution: To prevent the possibility of sanding dust or foreign
body being thrown into your face or eyes, never attempt to use your
sander without the box properly installed.
B) EMPTY THE CYCLONIC DUST BOX (See Fig. D1, D2)
For more efficient operation, empty the cyclonic dust box every
5-10mins. This will permit the air to flow through the box better.
To empty the box, press the latching lever in and pull off the box.
Then press the button at the rear of the box to open it, and shake out
dust.
3
USING THE DUST EXTRACTION ADAPTER (See Fig. E)
Your sander is equipped with a dust adapter, which is designed for
collecting dust. To attach, slide the adapter onto the outlet piece and
7 6
8
A
C
D.2
9
B
D.1
12
E