Table of Contents
Advertisement
Calibration Mode - Continued
Error Codes
7. Place ten pounds of test weights on
the scale and press the TEST key.
8. Press the TEST key. . .
or
9. Return switch 1 to the closed
position. . .
The scale is now tested, configured and calibrated. It is ready for use in your application.
Any system errors detected by the scale will be displayed as the letter E followed by
a two-digit error code. Press the TEST key to continue operation. If a calibration
error occurs the only way to clear it is by recalibrating the scale.
The error codes are broken down into two hexadecimal numbers, with each bit
defining a single error condition. The error codes are defined as follows:
Most Significant
Digit
8 4 2 1
After a brief wait DONE is displayed.
DIAG is displayed.
The scale returns to normal weighing mode.
Least Significant
Reserved
For
Future
Use
Digit
8 4 2 1
Calibration error
ROM error
RAM error
Serial EE PROM error
10
Advertisement
Table of Contents
