NCI 6702 User Manual page 10

Configuration Mode- Continued
Step-by-Step
Instructions for
ConF Mode
Follow these steps to access and configure the items in the ConF menu. Refer to
figure 3.
1. From the dIAG display press the ZERO key
OR
From normal weighing mode, move switch 1 to
Menu Mode or OPEN position, then press
the ZERO key. . .
2. Press the TEST key. . .
3. Press the TEST key. . .
4. Use the ZERO key to toggle
between the two choices. Press
the TEST key when the choice
you want is displayed. . .
5. Press the ZERO key once. . .
6. Press the TEST key. . .
7. Use the ZERO key to scroll
the choices found in Table 1.
When the choice you want is
displayed, press the TEST key. . .
8. Press the ZERO key twice. . .
9. Press the TEST key. . .
10. Press the ZERO key to scroll
through the choices. When the
choice you want is displayed,
press of the TEST key. . .
11. When you are finished with
configuring your scale press
the ZERO key three times,
which displays donE, then
press the TEST key. . .
ConF is displayed
FiLt is displayed. This stands for
filtering.
The current setting, FAST or SLO,
is displayed.
Your choice is accepted and the
display shows FILt.
BAUD is displayed.
The current baud and parity choice
is displayed.
Your choice is accepted and the
display FILt.
PROT is displayed. This stands for
protocol.
The current RS-232 communication
protocol is displayed.
Your choice is accepted and the
display shows FILt.
dIAG is displayed
8