Junction Box Installation - Heat & Glo GATEWAY Owner's Manual

E. Junction Box Installation
1. Disconnect junction box from bracket by removing
one screw.
2. Install wire strain relief into junction box bracket.

3. Route 110-120V wire through strain relief.
4. Secure ground and connect incoming hot and neutral
wires to the corresponding wires from junction box.
5. Tighten strain relief and reattach junction box to
bracket with one screw.

JUNCTION BOX BRACKET
Figure 12.3 Junction Box Access
36
NOTICE: DO NOT wire
110-120 VAC to wall switch.
JUNCTION BOX
PILOT HOLE
STRAIN RELIEF
Heat & Glo • GATEWAY • 288-900 Rev. AD • 3/13