Appliance Setup; Remove Glass Assembly; Remove Shipping Materials; Remove Grate Shipping Support - Heat & Glo GATEWAY Owner's Manual

14 14

Appliance Setup

A. Remove Glass Assembly
See Section 14.H.
B. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Remove Grate Shipping Support
• Remove the log pack and hood, if applicable.
• Bend top retaining tab of grate shipping support into
vertical position (see Figure 12.1).
• Lift grate slightly upward with one hand so that the grate
clears the support.
• Slide shipping support to side, remove and discard.
• Lower grate onto refractory.
Figure 12.1
D. Clean the Appliance
Clean/vacuum any sawdust or construction debris that
may have accumulated inside the fi rebox or underneath
in the control cavity.
E. Accessories
Install approved accessories per instructions included with

accessories.

Contact your dealer for a list of approved
accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
38 Heat & Glo • GATEWAY • 288-900 Rev. AD • 3/13
F. Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
• When placing Glowing Embers
should be taken so that the ports are not covered.
Place the dime-size ember pieces about 1/2 inch apart
near port holes in burner top, but not on or in between
the ports. For best performance do NOT place embers
on ports at rear of burner (see Figure 12.2). Failure to
follow this procedure will likely cause lighting and sooting
problems.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
EMBER
MATERIAL
INCORRECT

EMBER PLACEMENT

Figure 12.2 Placement of Embers
®
onto the burner care
FIRST
GRATE BAR
CORRECT
EMBER PLACEMENT