Important Safety Instructions When using your telephone 7.Place this telephone on a equipment, basic safety precautions stable surface. Serious damage should always be followed to and/or injury may result if the reduce the risk of fire, electric telephone falls. shock and persons including the 8.Do not cover the slots and following: openings on this telephone.
Page 4
Important Safety Instructions covered by the operating dangerous voltage points or instructions. Improper short out parts that could adjustment may require result in a risk of fire or extensive work by a electrical shock. Never spill qualified technician to liquid of any kind on the restore the telephone to telephone.
Page 5
Important Safety Instructions may explode. Check with installed using an acceptable local codes for possible method of connection. In some special disposal instructions. cases, the company’s inside wiring associated with a single ADDITIONAL SAFETY NOTES line individual service may be FOR CANADIAN USERS extended by means of a certified connector assembly (telephone...
Page 6
Important Safety Instructions CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. The Ringer Equivalent Number is an indication of the maximum number of terminals allowed to be connected to a telephone interface.
Page 7
Introducing the JV-35 Thank you for selecting the exciting new JV-35 from Ameriphone. It has been designed to meet the highest quality standards to provide you with years of convenient and trouble-free service Please read these operating instructions thoroughly before using your telephone.
Features on the JV-35 Ringer volume control switch Audio output jack AC adapter Announcement switch Tone / Pulse switch Emergency buttons Braille characters Raised letters for easy identification REDIAL button MEMORY button VOL control (volume) HOLD AMPLIFY button button TONE...
Base Plate until it JV-35. Then plug the snaps into place. AC Adapter into an electrical outlet. 4. Lift the handset and listen for a dial tone 5. Your JV-35 is ready to Fig. 5 - Phone base installation use. for wall mounting...
3. Plug in the short phone 6. Lift the handset and cord. listen for a dial tone. 4. Insert the AC Adapter 7. Your JV-35 is ready to cord into the receptacle use. on the back of the JV-35. Then plug the AC Adapter into an C.
Operating your JV-35 A. Dialing Pick up the handset and dial like any other telephone. As you dial, the numbers you Figure 8 - AMPLIFY Button are dialing will be announced (Seven, five, two, etc.) If you 2.Adjust the VOL control read Braille, you can use the to suit your hearing.
Operating your JV-35 warning printed in Braille to C. Adjusting The Tone the back of the handset (See, Diagram A). 1. When you hear a voice on the line, press the AMPLIFY button. Diagram A - JV35 handset Fig. 11- Amplify Button Note: In standard use, the 2.
Operating your JV-35 Note: When the JV-35 is on HOLD, if you pick up another phone that is on the same line, the JV-35 will automatically hang up. You Fig. 13 - Ringer Switch can continue your call on the other phone.
Operating your JV-35 G. Programming The 3. Press PROG button Emergency Buttons again. The Emergency Buttons can 4. Press one of the be programmed to dial Emergency buttons. numbers with one touch. You may wish to use these buttons for police, fire or medical response.
Operating your JV-35 H. Dialing With An Emergency 2. Enter the phone number Button as you would normally dial it. 1. Lift the handset. 2. Press one of the Emergency buttons. You will hear an announcement similar to: Fig. 20 - Entering Number “Emergency One”...
K. Recording Emergency button, repeat this Button Identification process from step 1. Announcements The JV-35 comes with factory J. Memory Dialing pre-recorded announcements to identify each Emergency button 1. Lift the handset. such as “Emergency One” etc. You can erase these 2.
Page 19
Operating your JV-35 beep” sound. This 4. After three seconds confirms the JV-35 is there will be a “beep” ready to be programmed. to tell you recording has stopped. Your recording will be played back immediately so you can check it, followed by a Fig.
PROG position. You will hear “Program Mode, Program Mode” followed by a “beep- Fig. 24 - Custom Announcement beep” sound to confirm the JV-35 is ready to L. Recording Memory be programmed. Button Identification Announcements Factory pre-recorded announcements identify each memory button.
5. Now you can repeat M. Recording Number steps 3 and 4 if you Button Announcements Ç want to change your The JV-35 also comes with announcement or if you factory pre-recorded want to record an announcements for the announcement for a...
Page 22
4. After one second there followed by a “beep- will be a “beep” to tell beep” sound to confirm you recording has the JV-35 is ready to be stopped. Your programmed. recording will be played back immediately so you can check it.
Operating your JV-35 the rest of the number N. Selecting Number buttons. Button Announcements To hear the number button 6. When you are finished announcements that were recording, hang up the pre-recorded at the factory, handset. slide the ANNOUNCEMENT switch to PRESET.
Audio Output port, Ameriphone that can be then plug the other end into used to plug the JV-35 your assistive listening device. directly into a speech processor. Fig. 34 - Audio Output port...
Page 25
Operating your JV-35 Connecting the Speech WARNING! During Processor: thunderstorms, avoid using telephones as electric shock from lightning can occur. Caution: Before plugging any cord into your speech processor, you must consult your implant manufacturer. • Plug the mono end of the plug into the speech processor.
Troubleshooting Chart If any problem should arise CAUSE AND SYMPTOM CORRECTIVE during operation of your ACTION JV-35, go through the suggestions listed below. Check all phone cord No dial tone Should the difficulty persist, connections. contact Ameriphone or your authorized dealer for...
It is designed to be connected to a compatible If this telephone equipment, the modular jack that is also JV-35 telephone causes harm to compliant. See installation the telephone network, the instructions for details. telephone company will notify...
Page 28
If your home has specially please contact Walker / wired alarm equipment Ameriphone, 1-800-874-3005. connected to the telephone line, If the equipment is causing ensure the installation of this harm to the telephone network,...
Page 29
AC Your JV-35 Telephone has been power sources. tested and found to comply with the limits of a Class B digital Customer-Owned Coin/Credit...
Page 30
Regulatory Compliance and can radiate radio (This increases the frequency energy and, if not separation between installed and used in the telephone equipment accordance with the and the receiver.) instructions, may cause 3. Connect the telephone harmful interference to radio equipment into an communications.
Page 31
Important Safety Regulatory Compliance Instructions Clarity, a Division of conditions may not prevent Plantronics, Inc. degradation of service in some 4289 Bonny Oaks Drive situations. Chattanooga, TN 37406 Telephone: 800-874-3005 Repairs to certified equipment should be made by an Industry Canada Technical authorized Canadian Specifications maintenance facility designated...
Page 32
Regulatory Compliance Important Instructions should contact the appropriate electric inspection authority, or electrician, as appropriate. The Ringer Equivalence Number is an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the...
JV-35 dealer of purchase. We will not pay will replace it at no charge. for loss of time, inconvenience, loss of use of your JV-35 If returned after 30 days but phone, or property damage within one year from the date...
Page 34
CANADIAN RESIDENTS: call date. Within 30 days of the Clarity at (800) 426-3738 date of purchase, return your for instructions. JV-35 to the place where you purchased it for immediate This warranty does not cover replacement. After 30 days, defects resulting from...
Page 35
Warranty telephone systems or more sophisticated switching systems. If your JV-35 is not covered by this warranty, call (800) 426-3738 for advice as to whether we will repair your JV-35 and other repair information. The repair shall be warranted for 90 days.
Important Instructions Specifications - JV-35 DECIBEL GAIN Maximum gain: 37dB at 3000Hz (Volume at Maximum setting and Tone at High setting) PHYSICAL DIMENSIONS Size: 9.5" x 7" x 3.25" Weight: 2.52 lbs. POWER AC Adapter 4 AA Alkaline non-rechargeable batteries...
Need help?
Do you have a question about the JV-35 and is the answer not in the manual?
Questions and answers
When I pick up the receiver, I hear the program mode announcement when I'm hoping to hear a dial tone. How do I return to the dial tone setting?
To return to the dial tone setting on the Ameriphone JV-35 after hearing the program mode announcement, hang up the handset.
This answer is automatically generated