Table of Contents
Advertisement
11
TIMER:
Press TIMER button at unit ON to set TIMER OFF, HOUR OFF blinking. Press TIMER button at unit OFF to set TIMER
ON, HOUR ON blinking. In this case, pressing + or -
changes time setting (time setting range 0.5-24hours). Press TIMER button again to confirm setting, HOUR O
stopping blink. If there is not any
will be canceled.
12
TURBO:
Press this button to activate / deactivate the Turbo function which enables the unit to reach the preset temperature in
shortest time. In COOL mode, the unit will blow strong cooling air at super high fan speed. In HEAT mode, the unit will
blow strong heating air at super high fan speed. (This function is not applicable for some models).
13
SLEEP :
Press this button to go into the SLEEP operation mode. Press it again to cancel. This function is available in COOL ,
HEAT (Only for models with heating function) or DRY mode to maintain the most comfortable temperature for you.
14
LIGHT:
Press LIGHT button to turn on the display's light and press this button again to turn off the display's light. If the light is
tunrned on,
3
4
3
and
About lock :
3
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller is locked,
In this case, pressing any button,
3
2
and
2
About switch between fahrenheit and cenrigrade
At unit OFF, press
6.2 Replacement of Batteries
1.Remove the battery cover plate from the rear of the remote controller. (As shown in the figure).
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Replace the battery cover plate.
Notes:
When replacing the batteries, do not use old or different batteries,
otherwise, it may cause malfunction.
If the wireless remote controller will not be used for a long time,
please remove batteries to prevent damage from leaking batteries.
The operation should be performed in its receiving range.
It should be kept 1m away from the TV set or stereo sound sets.
If the wireless remote controller does not operate normally, please
take the batteries out and replace them after 30 seconds. If still not
operating properly, replace the batteries.
28
operation of button within 5 seconds during HOUR ON/OFF blinking,
is displayed. If the light is tunrned off
blinks three times.
"
"
" - "
MODE
buttons simultaneously to switch between
and
button changes time setting. Holding down either button rapidly
disappears.
and
.
Function and Control
N/OFF
TIMER setting
is displayed.
Sketch map for
replacing batteries
Hide quick links:
Advertisement
Table of Contents
