TMC TI5VG+ User Manual page 44

Chapter 6 BIOS Configuration
The specifications of your drive must match with the drive
table. The hard disk will not work properly if you enter
incorrect information in these fields. If your hard disk drive
type is not matched or listed, you can use Type User to define
your own drive type manually.
Drive A / Drive B
These fields identify the types of floppy disk drive A or drive B that has
been installed in the computer. The available specifications are:
1.2MB
360KB
5.25 in. 5.25 in.
Floppy 3 Mode Support
This is the Japanese standard floppy drive. The standard stores 1.2MB in
a 3.5-inch diskette. You have four options to choose:
Disabled No 3 mode floppy drive installed. (default)
Drive A Installed 3 mode drive at drive A.
Drive B Installed 3 mode drive at drive B.
Both Installed 3 mode drive at drive A and B.
Video
This field selects the type of video display card installed in your system.
You can choose the following video display cards:
EGA/VGA For EGA, VGA, SEGA, SVGA
or PGA monitor adapters. (default)
CGA 40 Power up in 40 column mode.
CGA 80 Power up in 80 column mode.
MONO For Hercules or MDA adapters.
Halt On
This field determines whether the system will halt if an error is detected
during power up.
No errors Whenever the BIOS detects a non-fatal error,
the system will stop and you will be prompted.
All errors The system boot will not be halted for any error
that may be detected. (default)
All, But Keyboard The system boot will not be halted for a
keyboard error; it will stop for all other errors.
All, But Diskette The system boot will not be halted for a disk
error; it will stop for all other errors.
All, But Disk/Key The system boot will not be halted for a key-
board or disk error; it will stop for all others.
40
1.44MB 2.88MB
720KB
3.5 in. 3.5 in. 3.5 in.
TI5VG+ User's Manual