NAPCO GEM-K4RF Installation Instructions Manual page 5

• an assigned Key Fob Transmitter number (1—16);
• the Area number(s) to which the Key Fob Transmitter is designated;
• the 6-digit hexadecimal identification code with 1-digit checksum number printed on the transmitter (enter all
numbers and/or letters, including leading zeros, if any);
• Aux. 1 options (see programming worksheets);
• Aux. 2 options (see programming worksheets).
Quick Method (Using the GEM-K1CA keypad)
If a receiver is already installed in the panel, Napco Transmitter wireless points can be programmed automatically
("enrolled"). Note: (1) The transmitter point will be enrolled only if the signal strength is 3 or greater. (2) Enroll a sin-
gle-point device by merely powering it up. (3) Quick Method is not applicable to Key Fob Transmitters.
Enter the Program Mode. Scroll to the RF Transmitter Points entry screen and proceed as follows:
1. Enter the zone number to which the transmitter point will be mapped.
2. Press to enter the Enroll Mode. The red and green LEDs on the keypad will flash and will display as shown
B
below (GEM-K1CA).
Z N # X M I T # + C S P
3. Open the loop of the point that is to be programmed.
4. Install the transmitter battery. The keypad will indicate that the point has been successfully enrolled.
Multi-point transmitters can be mapped to successive zones simultaneously (Example 1) or to selected point by point
(Example 2).
Example 1: A 2 point transmitter has the ID Code number 410078. Map the two points to Zones 11 and 12 respectively.
1. Enter the Enroll mode as described in step 2 above.
2. Enter Zone "11".
3. Open the loops of points 1 and 2.
4. Install the transmitter battery. The keypad will beep twice to indicate that two points have been enrolled.
• Transmitter 410078, point 1 will be mapped to Zone 11
• Transmitter 410078, point 2 will be mapped to Zone 12
The keypad will now display Zone 12, the last zone enrolled.
Example 2. A 2-point transmitter has the 1D Code number 287613. Map point 1 to Zone 6 and point 2 to Zone 9.
1. Enter the Enroll mode as described above.
2. Enter Zone 06.
3. Open point-1 loop.
4. Install the battery. The keypad will beep once to indicate that one point has been programmed. (Transmitter point
1 will be mapped to Zone 6).
5. Enter Zone "09"
6. Open point-2 loop.
7. Remove the transmitter battery, then re-install it. The keypad will beep once to indicate that one point has been
programmed. (Transmitter 287613, point 2 is Zone 9).
CHECKING TRANSMITTERS
The status of each transmitter may be checked at the keypad. Referring to the control panel installation instructions
and the user's guide for the keypad in use, display transmitter status to show (a) the zone to which transmitter point is
mapped; (b) the transmitter's 6-digit RF ID number (c) the point number; (d) transmitter status (normal, open, low bat-
tery, etc.); and (e) the signal strength of its last transmission.
Testing Wireless Signal Strength with GEM-P1632/P816 Panels
To test the operation of wireless transmitters, proceed as follows.
1. Enter the Fault-Find Mode from the Function Menu (use Dealer Security Code to enter).
2. Fault a point of the transmitter to be tested by opening the loop. If the signal strength of the transmitter is 3 or
greater, the keypad will beep, as follows:
5