Room Sensor Installation - Harman The Accentra Pellet Stove Installation & Operating Manual

room Sensor and rear Shield Installation
14

room Sensor Installation

Fig. 19
The room sensor is a small temperature sensor on
the end of a 60" wire. This sensor is installed much like
a standard wall thermostat. Because it is so small, it
can be hidden along the trim of a doorway or even up
the leg of a coffee table. There is a remote room sensor
port on the rear of the unit for easy external connec-
tion. Use standard 18-2 thermostat wire to extend the
distance to the desired location (100' maximum). The
room sensor should be installed in the location where
you want to control the temperature.
NOTE: Distances of more than 25 feet from the
unit or in another room are not recommended. The
room sensor is essential for the Accentra's excellent
efficiency.
It is recommended that the room sensor be in-
stalled, even if only installed on the rear of the unit
as a return air sensor. There is an intake screen on
the bottom of the rear sheet metal enclosure. This is
an ideal place to tie wrap the sensor head to sense
return air temperature.
rear Shields
5/16" Hex Head
Screws (2 on
each side)
The rear insulated shields are split in the middle
for easy removal. Each shield has two 5/16" hex
head screws that only need to be loosened (NOT
REMOVED) to allow the shield to slide away from the
unit. NOTE: It is not recommended that the unit be
operated with the shields removed, due to the hot
and moving parts which they protect.
rEmINdErS
Fig. 21
Do not allow pellets or sawdust to build up on the
hopper lip.
Inspect the hopper lid gasket for damage. A good hopper
lid seal is very important for proper operation.
There is also a switch to determine the positioning
of the hopper lid. If the lid is not closed properly, the
feed motor and igniter will be disabled. (See wiring
diagram)
5/16" Hex Head
Screws (2 on
each side)
Fig. 20
Hopper Lid Foam
Gaskets
Hopper lip