Table of Contents
Advertisement
1. Power Jack
2. Audio/Video
Output Jack
3. External
Microphone
4. SD Card Slot
1.
Power Jack
Audio/Video
2.
Output Jack
External
3.
Microphone
4.
SD Card Slot
RJ-45 LAN
5.
Socket
Factory
6.
Default Reset
Rear View
The input power is DC 12V.
Audio/Video-out Jack allows this device to output audio and video signal.
Use the attached A/V cable to connect A/V device where white cable is for
audio and yellow cable is for video.
Connect a microphone to the IP camera.
User can insert a micro SD card into this slot for event recording.
The LAN socket is a RJ-45 connector for connections to 10/100Base-TX
Fast Ethernet cabling. This Ethernet port built N-Way protocol can detect
or negotiate the transmission speed of the network automatically. Please
use CAT-5 cable to connect the IP camera to a 100Mbps Fast Ethernet
network switch or hub.
This button is used to restore the all factory default settings. Sometimes
restarting the device will make the system back to a normal state.
However, if the system still got problems after restart, user can restore the
factory default settings and install it again.
9
5. LAN Socket
6. Factory
Default Reset
7. DI/DO
Connector
Advertisement
Table of Contents
