Table of Contents
Advertisement
A check mark appearing before the entry name will indicate that the ports are enabled.
NOTE
Some ISPs block access to port 80. Be sure to check with your ISP so that you can
open the appropriate ports accordingly. If your ISP does not pass traffic on port 80, you
will need to change the port the camera uses from 80 to something else, such as 8080.
Not all routers are the same, so refer to your user manual for specific instructions on
how to open ports.
Enter valid ports in the Virtual Server section of your router. Please make sure to check the box
on this line to enable settings. Then the device can be access from WAN by the router's WAN IP
Address.
By now, you have finished your entire PC configuration for this device.
86
Advertisement
Table of Contents
