Brother MFC-J2510 Quick Setup Manual page 22

Wired Network
c
Choose Wired Network Connection
(Ethernet), and then click Next.
d
When this screen appears, choose Change
the Firewall port settings to enable network
connection and continue with the
installation. (Recommended) and click Next.
If you are using a firewall other than the
®
Windows Firewall or the Windows
off, this screen may appear.
See the instructions provided with your firewall
software for information on how to add the
following network ports.
 For network scanning, add UDP port 54925.
 For network PC-Fax receiving, add UDP port
54926.
 If you still have trouble with your network
connection, add UDP ports 137 and 161.
22
NOTE
• If there is more than one machine connected to
the network, choose your machine from the list,
and then click Next.
This window will not appear if there is only one
machine connected to the network, the
machine will be chosen automatically.
• If your machine is not found over the network,
the following screen will appear.
®
Firewall is
Confirm your settings by following the
on-screen instructions.
e
The installation of the Brother drivers will
automatically start. The installation screens
appear one after another.
IMPORTANT
DO NOT cancel any of the screens during the
installation. It may take a few seconds for all
screens to appear.
NOTE
For Windows Vista
Windows
check box and click Install to complete the
installation correctly.
f
If Environmental Advice for Imaging
Equipment screen appears, click Next.
g
When the On-Line Registration screen is
displayed, follow the on-screen instructions.
Click Next.
h
If you do not want to set your machine as the
default printer, uncheck Set as Default Printer
and click Next.
Windows
® ®
and Windows
®
Security screen appears, click the
®
7, when the