Black & Decker BDPS200 Instruction Manual page 11

• Unscrew the lid from the side of the canister and properly dispose of cleaning solution.
K3
K2
• Refill the canister with a small amount of new cleaning solution (figure K1). Screw lid securely on canister.
• Plug in the cord and spray the cleaning
solution through the sprayer onto scrap
material for 5 seconds (figure K2).
• Unplug the sprayer from the power source.
• Properly dispose of cleaning solution.
• Remove the spray nozzle, by turning
counterclockwise, then remove the atomizer
(figure K3). Refer to figures C & C1.
K4 K5
• Unscrew the canister from the sprayer by
turning the collar as shown in figure K4.
Remove the pickup tube and filter and o-ring
from the sprayer. Clean the parts with the
cleaning brush in the appropriate cleaning
solution.
• Remove the front housing of the sprayer, by
pressing down on the release button and
pulling the front housing off of the sprayer
(figure K5, K6).
K6 K7
• Remove the piston and spring (figure K7).
11