Code Alarm ca 2051 Installation Manual page 7

9 YELLOW
Locate the vehicle's ignition wire at the ignition switch.
Verification: This wire registers voltage when the key is turned to the ON (or
RUN) position. The voltage does not drop out when the key is turned to the
START (or CRANK) position.
Connect the YELLOW wire to the vehicle's Ignition wire.
10 RED/WHITE
Locate the vehicle's trunk release wire at the trunk release switch.
Verification: This wire will register either positive voltage or ground when the trunk
release is activated.
This is a low current output, 200mA.
ca2051 rev B. 2011 Audiovox Electronics Corporation. All rights reserved.
IGNITION INPUT ( + )
TRUNK RELEASE OUTPUT ( - )
7