Limited Warranty - Dish Network Digital PVR User Manual

When you
press a button
on the remote
control, the
device does
not do what
you expect.
L W
IMITED
This warranty extends only to the original user of the DISH Network
control ("you," "your") and is limited to the purchase price of the remote
control. EchoStar Communications Corporation and its affiliated companies
("we," "our," "us") warrant this remote control against defects in materials or
workmanship as follows.
For one year from the original date of purchase, if we find the remote control is
defective subject to the limits of this warranty, we will replace the remote at no
charge for parts or labor. We warrant any such work done against defects in
materials or workmanship for the remaining part of the original warranty
period.
This warranty does not cover installation of the DISH Network
consumer instruction; physical set up or adjustment of any consumer electronic
device; remote control batteries; signal reception problems; loss of use of the
equipment; unused programming charges due to equipment malfunction;
cosmetic damage; damage due to lightning, electrical or telephone line surges,
fire, flood, or other acts of Nature; accident; misuse; abuse; repair or alteration
by other than our factory service; negligence; commercial or institutional use;
improper or neglected maintenance; equipment sold AS IS or WITH ALL
FAULTS; equipment removal or reinstallation; shipping damage if the
equipment was not packed and shipped in the manner we prescribe; nor
equipment purchased, serviced, or operated outside the contiguous United
States of America.
113737
• You may be trying
to control a device
other than the
receiver, without
pointing the remote
control directly at
the device.
• The remote control
may be missing
batteries, the
batteries may be
incorrectly placed
in the remote, or
the batteries may
be weak or dead.
• The remote may
not be set to the
mode for the
device you want to
control.
• The remote may
not be set up to
control the device.
ARRANTY

Limited Warranty

• Remember, the remote control uses IR
signals to control devices other than
the receiver. IR signals travel only 40
feet or less, and cannot go through
walls or other solid objects. You must
point the remote control directly at the
device, with no objects blocking the
signal path.
• Make sure the receiver and the remote
are set to the same address.
• If the remote has fresh batteries, check
whether they are placed according to
the label diagram. If not, remove them
and place them correctly.
• If the batteries are missing or dead,
insert fresh AAA-size batteries.
• Make sure to set the remote to the
mode for the device you want to
control.
• Make sure to set up the remote to
control all the devices you want to use.
TM
remote
TM
System;
Page 31