Pro-Form 350 User Manual page 8

5. Set the console assembly on the Handrails (71); insert
the excess wiring down into the right Handrail. Attach the
console assembly with four 3/4" Screws (2), two Console
Bolts (90), and two 1/4" Star Washers (73) as shown.
Make sure that no wires are pinched. Start all four
Screws and both Console Bolts before tightening
any of them.
6. Attach the Latch Housing (29) to the left Upright (69) with
two 3/4" Screws (2). Make sure that the large hole in
the Latch Housing is on the side shown. Do not over-
tighten the Screws.
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin as shown. Insert the pin into
the Latch Housing (29), and tighten the knob back onto
the pin.
7. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt
(see page 17). To protect the floor or carpet, place a mat under the treadmill.
5
Console Assembly
71
73
90
2
6
Knob
2
8
2
73
90
69
29
Spring
Collar
71
Pin