Table of Contents
Advertisement
G e t t i n g s t a r t e d
Check the model number of any charger before use with this
device. This device is intended for use when supplied with
power from ACP-12, ACP-7, ACP-8 and AC-1.
1. Open the flap on the bottom of the phone.
2. Connect the lead from the charger to the socket on the
bottom of the phone.
3. Plug the charger into a standard wall outlet.
The battery indicator
scrolls on the display
during charging. The text
Charging
is displayed
briefly if the phone is
switched on. If the
battery is completely
discharged, it may take a few minutes before the charging
indicator appears on the display, or before calls can be made.
You can use the phone while the charger is connected.
The charging time depends on the charger and the battery used.
Switching the phone on and off
Your device has an internal antenna.
Note: As with any other radio
transmitting device, do not touch
the antenna unnecessarily when
the device is switched on.
Contact with the antenna affects
call quality and may cause the
device to operate at a higher
power level than otherwise
needed. Avoiding contact with the antenna area when
operating the device optimises the antenna performance
and the battery life.
Hold the phone as you would any other telephone with the
antenna pointed up and over your shoulder.
11
Advertisement
Table of Contents
