Razor Ecosmart metro Owner's Manual page 5

ASSEMBLy AND SET-UP
Turn power switch "OFF" before conducting any maintenance procedures.
q Adjusting the Brakes
Tools required: 10mm open wrench
1
To adjust the brake cable play,
thread the brake lever adjuster
in or out 1/4 to 1/2 turn until
the desired brake adjustment is
attained. Most adjustments are
complete at this step. If brake
still needs further adjustment,
proceed to step 2.
q Charging the Battery
Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery prior to use.
• Initial charge time: 18 hours
• Recharge time: up to 12 hours,
depending on the level of depletion
Charger
Port
Charger
Plug
q Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and
your purchase. Low tire pressure can decrease the ride time of your unit.
1
Using a bicycle style pump
equipped for a Schrader-type valve,
inflate the tires to the PSI indicated
on the sidewall of the tires.
2
If the brake is too tight or too
loose, use a 10mm open wrench
to loosen the nut for additional
adjustment on the brake cable.
Securely tighten the nut when
finished.
• Run time: up to 40 minutes
• Average battery life: 250 charge/discharge cycles
1
Turn power to the "OFF"
position. Plug the charger into the
charger port as shown.
2
Plug the charger plug into a
wall outlet.
Note: If charger lights do not turn
on when plugged into the wall, try
another outlet.
4
Meijer.com
WARNING:
The brake is capable of skidding
the rear tire and throwing an
unsuspecting rider. Practice
in an open area free from
obstacles until you are familiar
with the brake function. Avoid
skidding to a stop as this can
cause you to lose control and/or
damage the rear tire.
WARNING: Always
disconnect your EcoSmart Metro
electric scooter from the charger
before cleaning.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status. Refer
to the illustration on the charger
unit for the actual "charging" and
"charged" status indications for
your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Be sure to properly align the
groove on the charger input
plug with the corresponding
socket on the case; otherwise,
no charging action will occur.
Note: The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate
tires, first make sure the pressure
gauge is working, then use very
short bursts to inflate to the correct
PSI. If you inadvertently over-
inflate the tire, release the excess
pressure immediately.