Troubleshooting Guide - Razor Ecosmart metro Owner's Manual

TROUBLESHOOTING GUIDE

Problem Possible Cause
Loose wires or connectors
Sometimes the scooter
doesn't run, but other
times it does
Motor or electrical switch damage
Normal response to charger use
Charger gets warm during
use
Brakes are not adjusted properly
Scooter does not stop
when applying the brake
Chain is too dry
Scooter makes loud noises
or grinding sounds
Brake rotor is dragging on brake
pads
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
Solution
Check all wires around the motor and all connectors to make sure they are
tight.
Contact your local Razor authorized service center for diagnosis and repair.
No action required. This is normal for some chargers and is no cause for
concern. If your charger does not get warm during use, it does not mean that
it is not working properly.
Refer to adjusting the brakes instructions on page 4.
Apply a lubricant such as 3 in 1
Use your fingers to twist the caliper adjuster in either direction until rotor is
centered between pads.
8
Meijer.com
TM TM
or Tri-Flow to the chain.