Lighting The Brass Burners - Lynx L30PSR Care & Use Manual

Lighting the Brass Burners

W A R N I N G
Never attempt to light grill
if odor of gas is present.
Hood must be open when
lighting. Keep face and
body parts as far from grill
as possible when lighting.
Always wait at least 5 min-
utes before attempting to
relight a hot burner.
Before proceeding, make sure
you have completed the check-
list on the previous page. These
checks should be performed be-
fore each use of the grill.
Follow these steps to light the
main brass grill burners:
1)
Open hood . Do not attempt to
light grill with the hood closed.
2)
Check to ensure that all burner
control knobs are set to OFF.
3)
Turn on main gas supply.
Purge if needed (see page 9).
4)
Push in and turn burner con-
trol knob to LITE. Hold knob in
for 5 seconds.
5)
If burner does not light, turn
knob to OFF, wait 5 minutes to al-
low gas to dissipate, and repeat
step 4 above.
PREHEATING THE GRILL
Before cooking, always preheat
the grill for best results. To pre-
heat the grill, light all main burn-
ers and set to HIGH, including
the ProSear burner. Close the grill
hood and allow to preheat for 10-
15 minutes, or until the tempera-
ture reaches 450°F.
1
After preheating, turn off all burn-
ers not required, carefully open
the hood, and adjust remaining
burners to desired temperature.
DO NOT LEAVE THE GRILL UNAT-
TENDED DURING THE PREHEAT
CYCLE OR AT ANY TIME WHILE
THE GRILL IS IN USE. DO NOT
ALLOW GRILL TO PREHEAT FOR
PROLONGED PERIODS OF TIME.
OVERHEATING THE GRILL CAN
CAUSE DAMAGE TO THE GRILL
AND PERSONAL PROPERTY.
MATCH LIGHTING
If burners will not light after sev-
eral attempts, the burners can be
match lit. If you've just attempt-
ed to light the burner with the
igniter, allow 5 minutes for any
accumulated gas to dissipate.
Make sure all knobs are in the
OFF position. Keep your face as
far away from the grill as pos-
sible. With the hood open, pass
the alternate lighting rod (Fig-
ure 14-1) with a lit paper match
clipped to the end past the ports
of the burner. Push and turn the
corresponding control knob of
the burner to LITE. If the burner
does not light in 4 seconds, turn
the knob off and wait 5 minutes
before attempting again.
Figure 1-1 -
Alternate
lighting rod.
LOW HEAT ADJUSTMENT
The valves on the grill feature
an adjustable low setting. Due
to fluctuations in gas pressure,
heating value or gas conversion,
you may feel it necessary to ad-
just gas flow in the low position.
Do not adjust the infra-red rotis
or ProSear burners.
1)
Light the burner.
2)
Turn the control knob to the
lowest setting (all the way coun-
ter-clockwise).
3)
Remove the knob.
4)
While holding the valve shaft
with pliers, insert a thin flat
tipped screwdriver into the shaft
and while viewing the burner,
adjust to a minimum stable flame
(see figure 14-2).
knob
removed
valve
stem
Figure 1- -
Adjusting
brass burner low heat setting.