Sample Record Mode - Akai MPC Reference Manual

5.12 SAMPLE RECORD MODE

In Sample Record Mode, you can record audio samples to use them in your tracks and
sequences.
To enter Sample Record Mode, press SHIFT + SAMPLE EDIT/ SAMPLE REC on your MPC
hardware.
In the MPC software, click on the Sample Record tab in the Upper section.
To record any audio, you need to connect an audio source to your MPC Renaissance or to
your computer's audio interface.
MPC Studio users: This section describes recording using MPC Renaissance as your sound
card. MPC Studio can't be used in this way, but you can use a separate audio interface
connected to your computer to record audio.
The following example describes the the sample recording procedure using the MPC
Renaissance hardware.
To record a signal, you need to connect a suitable microphone, instrument or sound generator
to the MIC IN jacks of your MPC Renaissance. You can also connect a turntable or CD player
by using the PHONO IN jacks. If a connected microphone requires phantom power, make sure
the PHANTOM POWER switch is set to "on." Turn phantom power off when you are not
recording.
Make sure to set the MIC / LINE switch on the rear panel as well as the MIC IN / PHONO IN
switch on the top panel to match your source. Incorrect settings can produce unwanted
distortion.
Make sure to also reduce the level of your audio system before you make any connections to
avoid peaks or feedback that may damage your speakers.
Use the REC GAIN knob to set the input level. This is located next to the MPC's display.
Use the cursor buttons to navigate to the record control parameters, described in detail below.
67