Akai MPC Reference Manual page 127

After that, click the Track Mixer Mode icon. You
will see channel strips for the Tracks on the left
and for the Plugin Programs on the immediate
right. Above each channel strip's Pan knob, you
will see where its audio is routed. The Tracks you
dealt with in the previous step will be routed to the
desired plugin.
Note: In the example shown on the right, Tracks 1
and 2 are sending volume and pan MIDI CCs to
the plugin. Some plugins do not support MIDI
volume and pan by default, in which case, adjust
this at the plugin track.
Control the volume and panning of a Track's note
events routed to the Plugin Program by adjusting
that Track's volume
respectively. Use
Program volume slider and pan knob to control
the volume level and panning routed to its output.
Tip: You can draw automation for each Track in
the Automation lane under the grid (in Main
Mode, Program Edit Mode, Track View Mode, or
Step Sequence Mode).
Press SHIFT + PROG MIX / TRACK MIX to enter Track Mixer Mode.
Use the cursor buttons to highlight the Mixer field at the top of the display, and then use the
data dial or -/+ buttons to switch between Track and Plugin. Track shows the information for
the Track channel strips, while Plugin shows the information for the Plugin Program channel
strips.
Use the F Buttons to select the desired tab, and then use the Q-Link Knobs to adjust the
levels of the Tracks or Plugin Programs.
Track view in Track Mixer Mode.
You can route Tracks to different plugins (if you have already loaded them) by clicking the drop-
down menu above the Pan knob. If you want to load more plugins, add new plugins to the Project
(explained above).
To show or hide the channel strips for the plugins or unused Tracks. See the Track Mixer Mode
Redesign section of this addendum for more information.
slider or pan
the corresponding
knob,
Plugin
Track Mixer Mode. Tracks 01 and 02 are routed to
the Vortex-I 001 Plugin Program, which is then
routed to Out 1,2.
Plugin view in Track Mixer Mode.
127