Honeywell Dolphin 6100 User Manual page 31

Mobile computer with windows embedded handheld 6.5
Hide thumbs Also See for Dolphin 6100:
Table of Contents

Advertisement

Main Battery Pack
Caution:We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result
in damage not covered by the warranty.
There are two Li-ion battery packs available for the 6100:
Standard Capacity:
Extended Capacity:
The Li-Ion battery pack is the primary power source for the Dolphin terminal as well as the internal backup
battery.
Changing the Main Battery Pack
Before installing a battery pack, press the Power button on the 28-key Dolphin 6100 to put the terminal
into
Suspend Mode
(see page 3-16) so that operations are suspended before removing the main power
source. The Dolphin 6100 is shipped with the battery separate from the unit. You will need to loosen the
hand strap, remove the battery door, insert the battery, and replace the battery door. Refer to the
instructions included in
Note: The battery door must be installed prior to booting the unit.
Charging Options
When the battery is installed in the terminal, you can use any of the peripherals listed below to charge the
battery.
Dolphin HomeBase/eBase Device
• Dolphin Comm/Charge Cable;
device using the USB connection if you do not have a wall adapter. There are two options that allow
either 100mA or 500mA of current over the USB connection. Access the option by selecting
Settings > System > Power > USB Charging (see see
8-1).
To fully charge the Li-Ion battery before installing it in the terminal, use the
Dolphin QuadCharger Device
in the back of either the Dolphin HomeBase or Dolphin eBase.
Charging Time
The standard capacity 2200mAh Li-ion battery pack requires four hours to charge to full capacity, while
the extended capacity 3300mAh pack requires six hours. It takes less time if the battery has some charge.
Li-ion 3.7V/2200mAh/8.1Wh
Li-ion 3.7V/3300mAh/12.2Wh
Installing the Main Battery
(see page 10-1)
Managing Main Battery Power
(see page 11-1) or insert the battery in the spare battery charging well
section (page 2-1).
(see page 3-14). You may charge the
Charging Terminal with USB Cable
Cover Locks
Main Battery
on page
>
3 - 13

Advertisement

Table of Contents
loading

Table of Contents