Axis 560 User Manual page 37

AXIS 560/660 User's Manual
Using ARP in UNIX
Notes:
Follow the instructions below to set the IP address using ARP.
AXIS 560 Ethernet Print Servers:
Type the following commands in the shell window:
arp -s <host name> <Ethernet address> temp
ping <host name>
Example:
arp -s npsname 00:40:8c:10:00:86 temp
ping npsname
The host will return
npsname is alive,
indicates that the address has been set and that communication is
established.
If the host name has not been mapped to an IP address, simply
replace the host name entry with the IP address in the example
above.
The ARP command varies between different UNIX systems.
Some BSD type systems expect the host name and node address in
reverse order. Furthermore IBM AIX systems will require the
additional argument ether. For example:
arp -s ether <host name> 00:40:8c:10:00:86 temp
When you execute the
experience a significantly longer response time than is usual.
Section 3: Basic Installation
or a similar message. This
command for the first time, you may
ping
37