Using The Valet Switch; The Status Light - Excalibur RS-340-EDPplus Operation Manual

Other Remote Start Features (cont'd)
4) Press LOCK on the transmitter� The engine will shut down (unless turbo timer is
on) and the status light will flash every 2 seconds to indicate it is ready to be remote
started�
NOTE: Manual transmission starting is canceled if you enter the vehicle after per-
forming the setup procedure� During remote starting, you have 20 seconds to turn
on the ignition key AFTER opening a door�

Using The Valet Switch

Valet Mode
Valet mode prevents the remote start feature from being activated� It also dis-
ables horn honks when locking or unlocking the doors� Valet Mode should be used
when you do not wish for remote starting to be operated, such as when you have
your vehicle serviced� To engage Valet Mode:
• With the system "unlocked", press and hold the Valet Switch for 3 seconds; the
Status Light will turn on and stay on to indicate Valet Mode� The horn will honk
once and the lights will flash twice. Once in Valet Mode, an attempt to remote start
will result in no response� Keep this in mind if remote start stops functioning� while
the system is in Valet Mode, the horn will honk once every time the ignition key is
turned OFF�
• To turn off Valet Mode, simply press & release the Valet Switch once. The Status
Light will turn off�
Emergency Override
If the system is locked, you cannot perform functions like transmitter or feature
programming� If you do not have a transmitter to unlock the system, you can perform
an emergency override to access the programming functions�
• With the system in a locked state, simply turn the ignition key to the RUN/ON
position and press and release the valet switch once�

The Status Light

The Status Light helps to visually confirms the status of the system and provides
a high level of visual deterrence� The Status Light is located in the window mount
receiver unit�
Normal System Status
1) Off = The remote starter system is off, in standby mode�
2) On Constant = The system is in the Valet Mode, with the remote starter system
disabled�
Starting System Status
The Status Light also indicates the remote start status:
3) Flashing Very Slow (once every 2 seconds): The system is in manual transmis-
sion remote start mode and awaiting a remote start command�
4) Flashing Slow (once per second): Remote start is on�
8