Table of Contents
Advertisement
(1) If ignition does not take place, press the igniter button 2 to 3 times.
(2) If ignition still does not take place, turn the burner control knob to the "OFF" position. Wait 5 minutes with lid open for the gas
to clear and repeat the lighting procedure
5.
After burner ignites, repeat the same procedure with any other burner desired.
6.
Adjust valve knob(s) to desired cooking temperature.
Using the Lighting Stick to Light the Main Burners
1.
Insert a match into the end of lighting stick. Light the match.
2.
Once lit, place the flame through the hole on grill body to reach the burner ports.
(As the fig. shown on right side).
3.
Press the valve knob and rotate it counter clockwise to the ''HIGH'' position. The
burner should light immediately. If more than one burner is desired, use the
carry over channel to light each adjacent burner by pressing the valve knob and
rotate it counter –clockwise to the ''HIGH'' position, repeat the same
procedure for each adjacent burner and continue in sequence until all desired burners
are lit.
4.
Adjust burners to the desired cooking temperature.
Precautions
1.
After lighting, observe the burner flame. Make sure all burner ports are lit.
2.
If the burner flame goes out during operation, immediately turn the gas "OFF". Open lid to let the gas clear for at least
5 minutes before re-lighting.
3.
Before cooking on the grill for the first time, operate the grill for approximately 15 minutes with the lid closed and the gas
turned on "HIGH". This will "heat clean" the internal parts, dissipate odor from the manufacturing process and painted finish.
4.
Clean the grill after each use. DO NOT use abrasive or flammable cleaners. This may damage parts of the grill and cause a
fire.
Confirm that the burner is properly lit and that the flame pattern is as desired (see fig. A,B and C below for the proper flame patterns).If
the flame pattern is other than normal, consult the troubleshooting guide on page 24 for corrective action.
FIG. A
Normal: Soft blue flames with yellow tips
between I inch - 2 inches high.
GPC2700JB
Owner's Manual
2 in.
Observe flame height when lit:
1 in.
Flame should be a blue/yellow color between 1 to 2 inches high.
0 in.
Out of adjustment: Noisy hard blue
flames – too much air.
FIG. B
20
FIG. C
Poor combustion: Wavy, yellow
flames- too little air.
Advertisement
Table of Contents
