Table of Contents
Advertisement
Step14
Align the holes in the handle heat insulator(30)
with the holes on the inside of the lid.
Insert the pre-assembled bolt in lid handle
(22),along with a heat resistant washer (O)
through the hole in lid (21) and the handle heat
insulator(30).
Seal with a flat washer(E) ,a lock washer (D) and
a wing nut(N)
Tighten by hand until secure.
GPC2700JB
Owner's Manual
(
)
E x2
(
)
D x2
(
)
B x2
31
36
Step13
Align the holes in down heat insulator (36)
with the holes in up heat insulator (31)and
the holes in burner .
Screw a bolt(B),along with a lock washer
(D)and a flat washer(E) t into the above
holes.
Put the burner (19) inside the body, make
certain the valve nozzle should insert into
the burner venturi tube.
Connect the ignition wire with the ignition.
Tighten by screwdriver until secure.
Hook the grease cup(20) under the grill
body
19
20
14
Advertisement
Table of Contents
