Table of Contents
Advertisement
LP (Propane) Gas Supply Connection
1. Always place the propane cylinder on the tank brackets located on the right side of the cart.
2. Always confirm that all burner control knobs are in the OFF position before activating the gas supply.
3. Before connection, be sure that there is no debris caught in the head of the gas cylinder, head of the regulator valve, or in
the head of the burner and burner ports.
4. Always connect the gas supply regulators as follows:
Insert the nipple of the valve coupling into the tank valve and tighten the connection
collar by turning it clockwise with one hand while holding the regulator with the other
hand.
(See diagram to right)
5. Disconnect the propane cylinder from the regulator valve when the grill is not in use.
6. Do not obstruct the flow of combustion air and ventilation air to the grill.
7. Keep ventilation openings of the cylinder enclosure free and clear from debris.
8. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install
the type of dust cap on cylinder valve outlet that is provided with the cylinder valve. Other
types of caps or plugs may result in leakage of propane.
DANGER
To prevent fire or explosion hazard when testing for a leak:
1.
Always perform the "leak test" on page 19 before lighting the grill and each time the cylinder is connected for use.
2.
Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3.
Conduct the leak test outdoors in a well-ventilated area.
4.
Do not use matches, lighters or a flame to check for leaks.
5.
Do not use grill until all leaks have been sopped, if you are unable to stop a leak, disconnect the propane supply, call for gas
appliance service or your local propane gas supplier.
Checking for Leaks
1.
Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three parts water.
2.
Make sure control knobs are in the "OFF" position.
3.
Spray some solution on the tank valve up to the regulator connection.
(See diagram to right).
4.
Inspect the solution at the connections for bubbles. If no bubbles appear,
the connection is secure.
5.
If bubbles appear, you have a leak. Go to step 6.
6.
Disconnect the regulator from the tank and reconnect. Make sure the connection is
secure.
7.
Retest with solution.
8.
If you continue to see bubbles, replace the cylinder.
Danger: Failure to open lid while igniting the grill's burners or not waiting 5 minutes to allow gas to clear if the grill does not
light, may result in an explosion, which could cause serious bodily injury or death.
WARNING: Never stand with your head directly over the grill when preparing to light the main burners, to prevent possible
bodily injury.
Main Burner
1.
Open lid while lighting burners.
WARNING: Attempting to light the burner with the lid closed may cause an explosion. Make sure there are no obstructions of
airflow to the gas unit. Spiders and insects can nest and clog the burner/venturi tube at the orifice. A clogged burner tube can
lead to a fire beneath the appliance.
2.
All valves must be in the "OFF" position.
3.
Open cylinder valve.
4.
Ignite only the burners you wish to use.
Press and turn the burner to "HIGH" then press the igniter button immediately. The burner should light in 3-5 seconds.
GPC2700JB
Owner's Manual
Connecting the Gas Cylinder
.
Lighting Your Grill
19
Advertisement
Table of Contents
