Table of Contents
Advertisement
Step8
Align the hole in control panel(15) with the
hole in the upper frame ,and then screw a bolt
(A) ,along with a lock washer(D) and a flat
washer (E)into each pre-drilled hole .
Tighten by screwdriver until secure.
GPC2700JB
Owner's Manual
Step7
Insert the valve shaft (14) into each
pre-drilled hole in the control panel (15) .
Screw a bolt (I) into the hole in the control
panel and in the valve to fasten the valve .
Insert the knob(16) onto the valve shafts.
Turn off the ignitor ring from the ignitor(13)
and Insert the ignitor into the pre-drilled
hole in the control panel , then put the ring
on the ignitor by turning .
Tighten by screwdriver until secure.
11
Advertisement
Table of Contents
